PAGE 1 - PAGE 2 - PAGE 3 - PAGE 4 - PAGE 5 - KW-1 Registry

HV Chokes after cleaning and painting

Antenna relay and filter after cleaning and installation
Compare this with the "before" photo directly below ...

Finally ... mounting components into newly painted cabinet. Rails in place; mod and HV
transforers, and the partially completed "HV choke/filter" assembly

Audio deck in place

Next step - harness connections and interlocks

Replacement modulation transformer (Dahl) installed after realizing that the original
broadcast transformer was not the correct. Note rubber pads to reduce "talk back."

Next few photos show upper and lower RF chassis being assembled and connected

Back to Index - Back to Top - Next Page